![]() Stitching should allow room for slider to run with ease, especially where cross seams and panel seams are forming multi-layer fabric construction. Not using proper grooved foot may lead to teeth damage by the needle.Ĭare should be taken at design stage when invisible zips cross side seams or go through the waistband Using half sewing foot can lead to incorrect stitching and the fabric getting caught in the path of the slider, thus dislodging it.Ĭare should be taken to not stitch through the zip’s teeth, to avoid slider jamming and damaging the tape. We strongly recommend to use dedicated feet for invisible zips which always deliver the correct result. Our technical advisers are always at hand to offer the help and support needed.įrequently Made Mistakes in Sewing Invisible Zips The bottom tape extensions of the zip should be secured to the fabric on both sides. Back tack for approximately 5mm.ġ0) The correct stop position is 2mm before hitting slider.ġ1) The incorrect stop position is when the sewing foot is hitting the slider.ġ2) Use a half foot to close the seam below the zip.ġ3) Stitch as near as possible to the zip insertion seam, overlapping by 5mm, back tack to secureġ4) Note that approximately 4 cm of the bottom of the zip will be unattached at this stage. Align the edge of the zip tape to the selvedge of the garment panel.ħ) Unfold the spiral teeth to be at right angles to the tape and lower the channel of sewing foot over the spiral as shown, with the nose of the foot above the top stop.Ĩ) Once the grooved foot is positioned, commence sewing, back tack for approximately 5mm to secure the end of the zip.ĩ) Sew along the length of the zip, repeating on both sides. This feed type will allow uniform pressure to be applied to the fabric and the zip, regardless of which side of the zip is sewn.Ħ) Turn the zip with puller to the fabric and fully open it. The nose and the channels are there to help keep the teeth vertical while stitching.Ĥ) The sewing foot should be centered properly by aligning the needle to the centre fin.ĥ) A balanced feed dog should be selected to obtain optimum appearance of the seam. Heat or pressure can damage the teeth of the zip.ģ) The correct grooved foot for invisible zips must be selected. ![]() Thus for a 20cm opening a 23cm zip is required.Ģ) Do not iron. Can be used in bedding, avoiding sharp turns and cornersġ) A concealed zip gives an effective opening approximately 2.5cm less than its length. To be preferred in garments made of fabrics with lycra ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |